iPod Touch Woes – Part Deux

The problems with my iPod Touch haven’t gone away just yet.

I was able to replace the headphone jack without too much trouble, in fact I would say it was a pretty easy fix. The old ribbon cable stub left from the snapping of the old ribbon cable came off the PCB without too much trouble at all. Just applied a bit of heat and up she came. Soldering the new ribbon cable+headphone jack assembly was very straight forward as well. I just made sure to clean the four pads off nicely, add a tiny bit of solder to each pad then put the ribbon cable down on top and apply some heat. From there I added a bit more solder to the top because the ribbon cable pads have little holes in them to allow the solder to flow through from the back to the front. All said and done, I think I did a really good job.

But, and here’s the kicker, I think ruined ANOTHER battery! Arg! These things must be ultra sensitive to shorting out or otherwise because I can’t figure out what else might have caused my THIRD battery to die on me. Yes, I’ve accidentally shorted it momentarily while fixing the headphone jack AGAIN.

Alas, perhaps it was not meant to be. First battery died because I tore the casing by accident, second battery because I got the damn thing wet. And now the third battery because I appearently cannot keep the red and black leads apart at all times…

At this point I’m not sure what to do. Give another battery a short? These things are cheap, so why not?

Leave a Reply

Your email address will not be published. Required fields are marked *