That’s right, my 1st generation iPod touch has been troublesome lately.
First, I took it snowboarding and it decides to get wet and short the battery somehow, killing it. Bad iPod! I told you not to get wet but you wouldn’t listen! At first I wasn’t sure if the battery really was dead or if the iPod itself had died. I quickly found out the battery was at fault when plugging it into my Macbook and seeing it come alive… too bad it was demanding that I restore it.
So, I tried to restore it. Turns out you can’t restore an iPod touch that doesn’t have a working battery. Part way through the restore, the iPod would die, presumably because it would disconnect from the USB power momentarily. Fine, I bought a new battery and soldered the three tiny little wires in and tried to restore it… and BAM! same problem! Ok, my fault, I didn’t let the battery charge enough. Once charged, I was able to perform the restore.
Now after waiting quite some time for the iPod backup to restore and my music to sync, I try plugging in my headphones to listen to some music. Nothing. The software volume slider is there and I can turn up the volume all the way but nothing. Some jiggling of the jack allows for one channel to come through all muddled. Open the iPod back up and I notice how I destroyed the ribbon cable going from the board to the jack during the battery replacement! Noooooooo.
I actually spent time trying to run four cables to jump the broken ribbon cable, but I didn’t heed my friend’s advice: There was no space for four wires in that tight case. Absolutely no way I could put the back on with those four “jumper” wires crudely soldered in. I also ended up shorting out at least two of the four leads, making my iPod think some kind of remote volume control was plugged in and preventing the display of the software volume controls! I decided to remove my failed attempt at fixing the headphone jack ribbon cable.
I’ve now ordered a replacement jack and I’m going to learn about the joys of soldering a ribbon cable to a tiny PCB. Wish me luck for when it arrives!
I also have lost the Software Volume control when soldering a new headphone jack on a Gen 1 32GB iPod Touch. I have gone through 3 headphone jacks so far. I can faintly hear sound, but no volume increase or decrease to be seen. I was wondering if there was any luck with other headphone jacks as I’m not so sure i’m shorting them all out in the same way.